eliminate storing in car audio systems
Car Audio August 30th, 2010
sometimes we feel the saturation on a standard car audio system and want to try to install a new audio system itself. but when the installation is complete, tmbullah a new problem, which is “storing”. storing other sound is the term (which is not desirable) that go into car audio systems. storing bebrerapa could happen due to factors such as:
1. lack of ground on which we connect the audio system.
2. quality spark plug wires are bad / leaking.
3. wire electrical system of our car audio systems have a poor quality or too small in size.
4. audio cable (RCA), whose quality is bad.
5. Ignition cable car that is damaged (usually older cars).
6. car battery that is damaged / soak.
to deal with the problems sometimes people feel dizzy to finish it and at the same time confused. STEP 2 but there you have to do to ease the process of “solving” this problem. among others:
1. note the age of the car. if the age of the car more than five years, first check the body and ignition cable car.
2. mobi note the body, whether experienced or not rusted. If so then you need to fix it, because sometimes the installers take ground / negative car battery from the car body.
3. Do not miss checking the battery, check whether the battery is less ari (for wet batteries), do not forget to clean the positive and negative battery terminal dar dirt, abrasives with fine sandpaper if necessary.
4. check whether the grounding cable from car battery to the car body still in good condition, add the ground of the new system when needed.
5. note the cable car spark plug carefully, do not let anyone peeling and leaking, if tenuous then reinstall the spark plug wires correctly.
6. if the above conditions are good enough, then you need malihat material quality of the audio system itself.
7. check whether the ignition cable is good and suitable amplifiers. power amplifier with 500W power 2 channels requires a cable with 10 AWG minimum size and so on, the greater the power amplifier, the greater the required cables.
8. audio cable (RCA) can sometimes be the factor that most determines the outcome of an audio installation, so try using a cable of good quality, usually have a coating / protective good.
9. keep the audio cable car system from the electrical cable cars, it aims to minimize the possibility of electromagnetic induction that can interfere with sound quality.
10. separate between the audio input cable to the amplifier, amplifier with electrical cables.
11. trim cabling that is not well insulated, with good insulation and will reduce the risk of knsleting that can happen.
If your car audio system is experiencing this problem try STEP 2 above.
